Ingenico iCT250 - Page 52

SKYZER TECHNOLOGIES PAGE 52 OF 116
NITRO INGENICO ICT250 AND IWL252 2015 PAYMARK SOFTWARE OPERATING GUIDE Version 1.0
9.0
GPRS PRIMARY
HOST PORT
33876
This parameter specifies the GPRS Primary Port Number of Paymark network. By
default the host port number is set to 33876.
10.0
GPRS SECONDARY
HOST PORT
33876
This parameter specifies the GPRS Secondary Port Number of Paymark network. By
default the host port number is set to 33876.
11.0
USE DNS Y/N
1-YES 2-NO
Press the corresponding number key and press ENTER to set for DNS or IP
Option 1 – to allow the terminal to use Paymark DNS address. Option 1 is
selected by default.
12.0
IP Primary
HOST DNS
direct.paymark.co.nz
This parameter specifies the Paymark IP Primary DNS address. By default, it is set
to direct.paymark.co.nz. Press ENTER
13.0
IP Secondary
Host DNS
direct2.paymark.co.n
This parameter specifies the Paymark IP Secondary DNS address. By default, it is
set to direct2.paymark.co.nz. Press ENTER
14.0
GPRS Primary
HOST DNS
gprs.paymark.co.nz
This parameter specifies the Paymark GPRS Primary DNS address. By default, it is
set to grps.paymark.co.nz. Press ENTER
15.0
GPRS Secondary
Host DNS
gprs2.paymark.co.nz
This parameter specifies the Paymark GPRS Secondary DNS address. By default, it is
set to gprs2.paymark.co.nz. Press ENTER
16.0
START TCP-IP Y/N
Terminal prompts to start TCP-IP link. Press ENTER to start the link or CLEAR to
exit without starting.
17.0
START GPRS Y/N
Terminal prompts to start GPRS link. Press ENTER to start GPRS or CLEAR to exit
without starting GPRS link to Paymark.