SKYZER TECHNOLOGIES PAGE 114 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE Version 1.00
12.13.2 Terminal Totals with Instant Tip
This function allows the merchant to determine the total count and amount of
all accepted transactions supported by the terminal since the totals where last
reset by the merchant.
PAYMARK EFTPOS
1.EFTPOS MENU
2.TIPPING MENU
3.HOSPITALITY MENU
4.ADMIN MENU
5.SUPERVISOR MENU
Press MENU key and then scroll through using down arrow key until ADMIN MENU
is shown on the display.
Press the corresponding number key or ENTER to access ADMIN menu.
ADMIN MENU
1.TOTAL
2.INQUIRY
3.CUTOVER
Press the corresponding number key or down arrow key to select TOTAL to perform
a shift totals.
1 Merchant 1
2 Merchant 2
3 Merchant 3
Only applicable with Multi-Merchant setup.
Select the corresponding number on the terminal to select the Merchant followed by
ENTER.
Totals will be printed immediately.
NOTE: This will include the instant tip amounts under purchase that were performed
for merchant’s knowledge.
RESET TOTALS?
ENTER=YES, CLR=NO
The user will be prompted whether the totals should be reset.
- If YES is selected, the terminal proceed to step 5.0 with totals to be reset. (To
check this, repeat steps 1-2. Totals should all appear as $0.00 on the printout.)
- If NO is selected, terminal will return to idle without resetting the totals. (To check
this, repeat steps 1-2. Totals should remain the same.)
PRINT TIP REPORT
AND RESET?
The user will be prompted whether print the tip report and reset.
- If YES is selected, the terminal proceed with totals to be reset and print off the
instant tip report for the merchant outlining the number of tip transactions that were
performed.
- If NO is selected, terminal will return to idle without resetting the totals.
To Next Page
Loading...
Need help?
General
