SKYZER TECHNOLOGIES PAGE 37 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE Version 1.00
5.4.2 To Deactivate Multi-Merchant Configuration
This function allows the merchant to deactivate multi-merchants on the
terminal if not required.
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
Press 3 to Deactivate Active Merchants
Terminal will display with all active merchants that was previous configured. To
deactivate multi-merchant from the terminal, key in the active merchant number
that the merchant desire to have active followed by the ENTER. This will result in
deactivating the other active merchants on the terminal.
Example: To deactivate merchants 2 to 5, enter the merchant number 1 to have
active and other active merchants will be deactivated.
Terminal is now in configuration mode. Press CANCEL to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity
To Next Page
Loading...
