SKYZER TECHNOLOGIES PAGE 46 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE Version 1.00
5.9 CONFIGURE RECEIPT HEADER AND FOOTER
This function allows the merchant to customize the receipt merchant name
and address lines.
NOTE: The footer lines will only be printed off on the customer copy of the
receipt.
Press FUNC
CONFIG RECEIPT
HEADER & FOOTER?
ENTER OR CLEAR
Press ENTER to configure the parameters or CLEAR to cancel and return to idle
screen
ERASE EXISTING
HEADER & FOOTER?
ENTER OR CLEAR
Only applicable if header and footer was previously configured
Press ENTER to erase the existing header and footer that were previously
configured on the terminal or CLEAR to keep the previous configuration and make
minor alteration to the header and footer.
MERCHANT NAME
XXXXXXXXXXXXXXXX
This parameter specifies the Merchant Name. It can be configured by entering the
desired Merchant Name use the numeric keypads then the FUNC key to access the
alpha characters then press ENTER
Note: Up to 20 characters can be entered per line.
ADDRESS LINE 1
XXXXXXXXXXXXXXXX
This parameter specifies the address in which you would like to appear on printed
receipt. It can be configured by entering desired address use the numeric keypads
then the FUNC key to access the alpha characters then press ENTER
NOTE: Two address lines can appear on printed receipted
Example: Address Line 1 - 1066 COOKS RD
ADDRESS LINE 2
XXXXXXXXXXXXXXXX
This parameter specifies the address in which you would like to appear on printed
receipt. It can be configured by entering desired use the numeric keypads then the
FUNC key to access the alpha characters then press ENTER
Example: Address Line 2 - PENROSE
FOOTER LINE 1
XXXXXXXXXXXXXXXXXX
This parameter allows up to ten lines of text to be printed at the bottom of the
cardholder’s copy of the receipt.
It can be configured by entering desired footer use the numeric keypads then the
FUNC key to access the alpha characters then press ENTER
To Next Page
Loading...
Need help?
General
