Ingenico iWL25 Series - IWL252 Bluetooth EFTPOS Configuration

SKYZER TECHNOLOGIES PAGE 28 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE Version 1.00
5.2 IWL252 BLUETOOTH EFTPOS CONFIGURATION
The EFTPOS Configuration option enables the terminal to be configured to
operate as an EFTPOS terminal and must be done before the terminal can
process transactions.
Step
Terminal Display
Comment
1.0
Press FUNC
2.0
FUNCTION?
Enter 3824 and press ENTER.
3.0
CONFIG PARAMS?
ENTER OR CLEAR
ENTER to configure the parameters or CLEAR to cancel and exit to idle prompt.
4.0
TERMINAL ID?
XXXXXXXX
This parameter specifies the Terminal ID assigned by Paymark. Key in the 8 digit
terminal ID and press ENTER.
5.0
MERCHANT ID?
XXXXXXXXXXX
This parameter specifies the Merchant ID assigned by Paymark. Key in the 11 digit
merchant ID and press ENTER.
6.0
NII?
001
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark. Press ENTER.
7.0
COMMS MODE?
1-DIAL-UP
Select the preferred COMMS mode by pressing the corresponding number key. By
default 1-DIAL-UP is always selected.
Press 1 for Dial-up configuration followed by ENTER and proceed wi
th the
configuration.
8.0
2-TCP-IP / DIAL
Press 2 for TCP-IP/Dialup as backup configuration followed by ENTER and
proceed with the configuration.
9.0
3-TCP-IP
Press 3 for TCP-IP configuration followed by ENTER and proceed with the
configuration.