SKYZER TECHNOLOGIES PAGE 35 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE Version 1.00
5.4 MULTI-MERCHANT CONFIGURATION
This function is used to configure the terminal for Multi-merchant operation. The
terminal can support up to 8 Merchants.
NOTE: After activating the Multi-Merchant configuration, please return to
EFTPOS configuration for Multi-Merchant Function 3824 to enter the Terminal
and Merchant ID’s for the active merchants.
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
ACTIVE MERCHANTS
12345678
Press 3 to Set Active Merchants
Enter the number (from 1 – 8) for each individual merchant you wish to activate
and press ENTER
Example: To activate merchants 1 to 5, enter 12345
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
MERCHANT 1 NAME
MERCHANT 1
Press 4 to Set Merchant Name
To change the merchant name, use the numeric keypad then the FUNC key to
access the alpha characters. Press ENTER to advance to the next merchant name
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
To Next Page
Loading...
