Ingenico iWL25 Series - Page 25

SKYZER TECHNOLOGIES PAGE 25 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE Version 1.00
7.0
CONFIGURATION
1-Modem Setup
2-Ethernet Setup
3-Battery Setup
4-Cradle Setup
Press 4 to select CRADLE SETUP
8.0
CRADLE SETUP
1-Association
2-Advanced
3-Base State
Press 1 to select ASSOCIATION
9.0
ASSOCIATION
1-New Base
2-Select Base
3-Remove Base
4-Print Bases
Pairing Base
Press 1 to select NEW BASE to associate terminal with that base
Unpairing Base
To disassociate terminal from a base, select option 3 – ‘REMOVE BASE’. Proceed
with step 12.0
10.0
ASSOCIATIONSUCCESSUL
OK OK
On selecting ‘NEW BASE’ option, the terminal will immediately perform association
with that base. The terminal will display the outcome of the association attempt.
Press ENTER.
11.0
BASE UPDATE
1-This Base (IR)
2- < Base Name >
When the terminal is successfully associated with a base, the terminal will prompt
for ‘BASE UPDATE’ menu. Select option 1; the base that the terminal is newly
associated with to configure the base i.e. Modem configuration.
12.0
REMOVE BASE
1- <Base Name 1>
2- <Base Name 2>
If ‘REMOVE BASE’ was selected, the terminal will display the name of the bases it
is associated with. Select the name of the base to disassociate from followed by
ENTER.
13.0
Press the CANCEL key unless and until you exit out from the menu and return to
idle screen.