95
Using the Remote Controller with Other Components
—Continued
Running Macros
Programmed macros can be run as follows.
Naming Macros
You can name your macros as follows. Names may con-
tain of up to five characters.
1
Press the [Macro] button.
2
Roll the scroll wheel to select the
macro’s number, and then press
the scroll wheel.
The actions in the macro are performed
in the order in which they were pro-
grammed.
1
Press and hold the [Custom] but-
ton for more than three seconds.
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
“MACRO,” and then press the
scroll wheel.
3
Roll the scroll wheel to select
“NAME,” and then press the
scroll wheel.
4
Roll the scroll wheel to select the
number of the macro that you
want to name, and then press the
scroll wheel.
5
Roll the scroll wheel to select a
character, and then press the
scroll wheel to set it.
The following characters are available.
6
Repeat step 5 until you’ve
entered all 5 characters.
The previous menu reappears.
If the name you are entering consists of
less than five characters, enter spaces at
the end to make it up to five.
Macro #1 selected
1st character
Macro #1 selected
1st character set
0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J
K L M N O P Q R S T U V W X Y Z + –
= < > _ / * space
_
DTR-8.4En.book Page 95 Thursday, October 16, 2003 11:09 AM
To Next Page
Loading...
Need help?
General
