Integra DTR-8.4 User Manual

40
Basic Setup —Continued
Speaker Impedance
This section explains how to specify the impedance of
your speakers. Check the backs of your speakers or their
manuals to determine their impedance.
Note:
Before you change this setting, turn down the volume.
Notes:
• This procedure can also be performed by using the
DTR-8.4’s [Setup] button, [ ]/[ ]/[ ]/[ ] but-
tons, and [Enter] button.
Speaker Settings
1
Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
1
2–4
1, 5
2, 3
2
Use the Up/Down [ ]/[ ] but-
tons to select “0. Hardware
Setup,” and then press the
[Enter] button.
The Hardware Setup menu appears.
3
Use the Up/Down [ ]/[ ] but-
tons to select “1. Speaker Imped-
ance,” and then press the [Enter]
button.
The Speaker Impedance menu appears.
4
Use the Left/Right [ ]/[ ] but-
tons to select:
4 ohms: Select if the impedance of any
one speaker is between 4 and
6 ohms.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Press the [Setup] button.
The setup menu closes.
Advanced Menu
0.Hardware Setup
0-1.Speaker Impedance
a.Minimum :6 ohms
DTR-8.4En.book Page 40 Thursday, October 16, 2003 11:09 AM

Integra DTR-8.4 Specifications

General

Brand	Integra
Model	DTR-8.4
Category	Receiver
Language	English