4.1. Setting Up the BTS GUI Running Environment
To run BTS GUI, including the Power Monitor and Clock Controller GUI, you must
download and install Java runtime including OpenJDK and OpenJFX on your systems
and set up the running environment. This is a one-time procedure, so if you have
already completed it before, you do not need to do it again unless the Java version
upgrade is required.
4.1.1. Downloading OpenJDK
1. Download the Temurin* OpenJDK. Refer to the related information for the
download link.
2. Select Architecture x64, Package Type JRE, and Version 11.
a.
For the Windows system, choose the JRE.zip format file.
b.
For the Linux system, choose the JRE.tar.gz format file.
Related Information
Temurin* OpenJDK
4.1.2. Downloading OpenJFX
1. Download the Gluon* OpenJFX. Refer to the related information for the download
link.
2. Select JavaFX version 17.0.2.
a. For the Windows system, download the JavaFX Windows x64 SDK.
b. For the Linux system, download the JavaFX Linux x64 SDK.
Related Information
Gluon* OpenJFX
4.1.3. Installing OpenJDK and OpenJFX
You have two downloaded compressed files. Follow these steps to install them.
1. On Windows system, Altera recommends you to unzip the files and put them in
the following directory:
•
C:\Program Files\Java\jre
•
C:\Program Files\Java\jfx
4. Board Test System
776646 | 2024.11.21
Send Feedback
Agilex
™
7 FPGA I-Series Transceiver (6 × F-Tile) Development Kit User Guide
15
To Next Page
Loading...
