2. Getting Started
2.1. Before You Begin
You must check the kit contents and inspect the boards to verify that you received all
of the items in the box before using the kit of installing the software.
In case any of the items are missing, you must contact Altera before you proceed.
Important: Read the Appendix C.1—Safety and Regulatory Information for safe operation and
regulatory adherence.
2.2. Handling the Board
When handling the board, it is important to observe static discharge precautions.
Caution: Without proper anti-static handling, the board can be damaged. Therefore, use anti-
static handling precautions when touching the board.
Caution: This development kit should not be operated in a vibration environment.
2.3. Software and Driver Installation
This section explains how to install the following software and driver:
• Quartus
®
Prime Pro Edition software
• Intel
®
SoC FPGA Embedded Development Suite (SoC EDS)
• Agilex 7 FPGA I-Series Transceiver Development Kit software
• Intel FPGA Download Cable II driver
776646 | 2024.11.21
Send Feedback
©
Altera Corporation. Altera, the Altera logo, the ‘a’ logo, and other Altera marks are trademarks of Altera
Corporation. Altera and Intel warrant performance of its FPGA and semiconductor products to current
specifications in accordance with Altera’s or Intel's standard warranty as applicable, but reserves the right to
make changes to any products and services at any time without notice. Altera and Intel assume no
responsibility or liability arising out of the application or use of any information, product, or service described
herein except as expressly agreed to inwriting by Altera or Intel. Altera and Intel customers are advised to
obtain the latest version of device specifications before relying on any published information and before placing
orders for products or services.
*Other names and brands may be claimed as the property of others.
ISO
9001:2015
Registered
To Next Page
Loading...
