Intel Altera Agilex 7 - Table of Contents

Contents
1. Overview........................................................................................................................ 4
1.1. Block Diagram.......................................................................................................5
1.2. Feature Summary..................................................................................................5
1.3. Box Contents........................................................................................................ 6
1.4. Recommended Operating Conditions........................................................................ 6
2. Getting Started............................................................................................................... 7
2.1. Before You Begin................................................................................................... 7
2.2. Handling the Board................................................................................................ 7
2.3. Software and Driver Installation.............................................................................. 7
2.3.1. Installing the Quartus Prime Pro Edition Software...........................................8
2.3.2. Installing the Intel SoC EDS........................................................................ 8
2.3.3. Installing the Development Kit.....................................................................9
2.3.4. Installing the Intel FPGA Download Cable II Driver....................................... 10
3. Development Kit Setup................................................................................................. 11
3.1. Default Settings...................................................................................................11
3.2. Powering Up the Development Kit.......................................................................... 12
3.3. Performing Board Restore..................................................................................... 12
3.3.1. Restoring Board System MAX 10 with Default Factory Image..........................12
3.3.2. Restoring Board QSPI Flash with the Default Factory Image........................... 13
4. Board Test System........................................................................................................ 14
4.1. Setting Up the BTS GUI Running Environment......................................................... 15
4.1.1. Downloading OpenJDK..............................................................................15
4.1.2. Downloading OpenJFX.............................................................................. 15
4.1.3. Installing OpenJDK and OpenJFX................................................................15
4.1.4. Setting Up the Quartus Prime Software for BTS Operation............................. 16
4.1.5. Running the BTS GUI................................................................................16
4.2. BTS Functionalities...............................................................................................18
4.2.1. The Bottom Info Bar.................................................................................18
4.2.2. The Configure Menu................................................................................. 18
4.2.3. The Sys Info Tab......................................................................................19
4.2.4. The GPIO Tab.......................................................................................... 20
4.2.5. The XCVR Tab..........................................................................................21
4.2.6. The Memory Tab...................................................................................... 31
4.3. Control On-Board Clock through Clock Controller GUI............................................... 34
4.4. Monitor On-Board Power Regulator through Power Monitor GUI.................................. 37
4.5. Identify Test Pass or Fail-based on BTS GUI Test Status.............................................38
5. Development Kit Hardware and Configuration.............................................................. 40
5.1. Configuring the FPGA Device by Active Serial (AS) Modes (Default Mode).................... 40
5.2. Configuring the FPGA Device by Avalon Streaming Modes..........................................40
6. Custom Projects for the Development Kit..................................................................... 41
6.1. Add SmartVID Settings in the Quartus Prime QSF File...............................................41
6.2. Golden Top......................................................................................................... 41
Contents
Agilex
™
7 FPGA I-Series Transceiver (6 × F-Tile) Development Kit User Guide
Send Feedback
2