Intel Altera Agilex 7 - Error Control

Error Control
This control displays data errors detected during analysis and allows you to insert
errors:
• Detected Errors: Displays the number of data errors detected in the received bit
stream.
• Inserted Errors: Displays the number of errors inserted into the transmit data
stream.
• Bit Error Rate: Calculates the bit error rate of the transmit data stream.
• Insert: Insert a one-word error into the transmit data stream each time you click
the button. Insert is only enabled during transaction performance analysis.
• Clear: Resets the Detected Errors counter and Inserted Errors counter to
zeros.
Run Control
• TX and RX performance bars: Show the percentage of maximum theoretical
data rate that the requested transactions can achieve.
• Start: This control initiates the loopback tests.
• Data Rate: Displays the XCVR type and data rate of each channel.
Figure 15. QSFPDD NRZ—Data Rate
4. Board Test System
776646 | 2024.11.21
Agilex
™
7 FPGA I-Series Transceiver (6 × F-Tile) Development Kit User Guide
Send Feedback
24