Interlogix TruVision DVR 44HD - Monitor Connections; Rack Mounting

1BChapter 2: Physical installation
TruVision DVR 44HD User Manual 11
Description Use Specification
13
. Four alarm outputs Connect physical alarm outputs such as
a siren, flash, relay.
14
. Ground Connect to ground.
15
. Power cord Connect a PSU. The PSU is shipped with the recorder.
16
. Power switch Turn the recorder on/off.
Monitor connections
Connect a monitor to one of the recorder’s outputs (BNC/VGA/HDMI). The recorder provides a
1 Vp-p analog signal. See Figure 1 on page 10 for connecting a monitor to a recorder.
The recorder supports up to 1280 × 1024 / 60 Hz resolution in VGA/HDMI. The monitor
resolution should be at least 800 × 600. Adjust your monitor accordingly to this resolution.
Rack mounting
The recorder is 1.5U and is rack mountable using the rack mount ears delivered with the
product. See Figure 6 below.
Figure 2: Rack-mount installation
To install the racks:
1. Attach the two small front-rack mount ears (A) to the recorder (supplied).
2. Attach the recorder to the front rails (B) (screws not supplied).