12BChapter 13: Alarm and event setup
TruVision DVR 44HD User Manual 95
9. Click Exit to return to live view.
Remote alarm host setup
If a remote alarm host is set, the recorder sends a signal to the host when an alarm is triggered.
The remote alarm host must have the TruVision Navigator server software installed.
To set up a remote alarm host:
1. From the menu toolbar, click Alarm & Event Setup > Alarm Host Setup.
2. Enter Alarm Host IP and Alarm Host Port values.
Alarm host IP represents the IP of the remote PC where the Network Video Surveillance
software installed. The alarm host port value must be the same as software’s alarm monitor
port. Up to three alarm hosts can be set. For each alarm host, the default port is 5001,
5002, and 5003.
3. Click Apply to save the settings.
4. Click Exit to return to live view.
To Next Page
Loading...
