Interlogix TruVision DVR 44HD - Pppoe Settings

10BChapter 11: Network settings
78 TruVision DVR 44HD User Manual
Option Description
9.
Multicast IP
Enter a D-class IP address between 224.0.0.0 to 239.255.255.255. Only specify
this option if you are using the
multicast function. Some routers prohibit the use of
multicast function in case of a network storm.
10.
Enable Telnet
For Technical Support purposes only. For security reasons, the Telnet port is
disabled by default.
11.
IPv6 Address 1
Enter the IPv6 address for the recorder.
This is the IP address of the local network
to which the recorder is connected.
Default value is fe80::240:3dff:fe7e:926f/64
12.
IPv6 Address 2
When the recorder is connected to an external network (such as the internet), the
second IPv6 address is automatically assigned.
13.
IPv6 Default
G
ateway
Enter the IPv6 address of your network gateway so the recorder
will be recognized
within the network. This is typically the IP address of your router.
14.
MTU (bytes)
Enter a value between 500 and 9676. Default is 1500.
15.
Alternate DNS
Server
Enter the alternate domain name server to use with the recorder.
It must match the
DNS server information of your router. Check your router’s browser interface or
contact your ISP for the information.
16.
HTTP Port
Use the HTTP port for remote internet browser access.
Enter the HTTP port value, which can be any port number that is not occupied.
The default value is 80.
17.
RTSP Service P
ort
The RTSP (Real Time Streaming Protocol) is a network control protocol designed
for use in entertainment and communications systems to control streaming media
servers.
Enter the RTSP port value, which can be between1 to 65535. The default value is
554.
18.
Total Bandwidth
Limit (Kbps)
The total outgoing
bandwidth limit is a threshold you can set to limit the amount of
outgoing bandwidth that is being handled by the recorder.
19. Click Apply to save the settings and Exit to return to live view.
PPPoE settings
Although not usually used, you can connect the recorder directly to a DSL modem. To do this,
you need to select the PPPoE option in the network settings. Contact your ISP to get the user
name and password.
To configure PPPoE settings:
1. From the menu toolbar, click Network Settings > PPPoE.
2. Check the enable PPPoE box.
3. Enter your user name and password and confirm the password.
4. Click Apply and manually reboot the recorder to save the settings.