Interlogix TruVision DVR 44HD - IP Camera Status

9BChapter 10: Camera setup
TruVision DVR 44HD User Manual 57
Figure 19: Overview of analog cameras window (8-channel recorder model shown)
List of all the analog channels (number depends on
recorder model).
Click to live view the selected analog camera.
Disable an analog camera in order to add
an IP camera.
To enable or disable an analog camera:
1. From the menu toolbar, click Camera Setup > Analog Camera Overview.
2. In the Status section, check the boxes of the cameras that you want to enable. Uncheck
those you want to disable in order to add an IP camera.
3. Click Apply to save the changes.
4. A pop-up message will appear asking if you want to reboot the system. Click Yes.
IP camera status
The IP camera status menu allows you to add, edit and remove cameras to the recorder, as
well as update the cameras’ firmware.
The maximum number of IP cameras that can be connected depends on the number of analog
cameras enabled. You may need to disable an analog camera to add an IP camera.