56 TruVision DVR 44HD User Manual
Chapter 10
Camera setup
Use the Camera Setup menu to configure analog and IP cameras. You can also configure the
camera OSD, snapshots, recording settings, motion detection, privacy masking, camera
tampering, PTZ configurations and V-stream settings.
Note: Not all settings are available for IP cameras. For advanced IP camera settings, please
consult the IP camera web browser interface.
Supported IP cameras
The recorder supports the following IP cameras:
HD-TVI technology cameras (HD and Full HD)
Standard analog cameras
TruVision IP cameras at HD and full HD resolution
Analog camera setup
The recorder can support up to 16 cameras depending on the model, which can be a mix of
analog and IP cameras. By default, all camera channels in the recorder are analog. You need
to disable an analog camera in order to add an IP camera.
You can quickly see an overview of all the analog cameras and their status in the Analog
Camera Overview screen (see Figure 19 on page 57). The number of cameras displayed
depends on the recorder model. You can also select a camera to live view the image.
When an analog camera is enabled or disabled, the system must reboot for the changes to take
effect.
To Next Page
Loading...
