Intermec EasyCoder PC4 Service Manual

Intermec EasyCoder PC4—Service Manual 79
Chapter 12—Troubleshooting
Description:
No “Out of ribbon” detection
Possible Cause of Problem and Suggested Measures:
• No silver-colored ribbon trailer.
- e ribbon end sensor can only detect out-of-ribbon conditions if the
emitted light is reflected back by a silver-colored section at the end of
the ribbon.
• Ribbon end sensor out of order.
- Check for foreign objects that can block the light beam and for bad
connections. Replace if necessary.

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing