Intermec EasyCoder PF4i Service Manual

Intermec EasyCoder PF2i, PF4i, and PF4i Compact Industrial—Service Manual 233
Chapter 15—Troubleshooting
Description:
No transfer printout.
Possible Causes and Suggested Remedies:
• Refer to Chapter 15.12 for general printout troubles.
• Bad ribbon load.
- Transfer ribbon loaded incorrectly so the ink-coated side does not face
the receiving face material. Reload ribbon.
Description:
Ribbon fed out in front of printer.
Possible Causes and Suggested Remedies:
• Printer is set up for direct thermal printing, but a ribbon is loaded.
- Remove ribbon or change the paper type setup to thermal transfer.
• Ribbon rewind motor does not run.
- Cable between ribbon motor and P6 on the Power Supply Unit
broken or not correctly connected?
- Faulty ribbon sensor? See Chapter 15.11.
- Faulty ribbon motor? Replace.
- Faulty CPU board? Replace.
- Faulty Power Supply Unit? Replace.

Intermec EasyCoder PF4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power consumption (standby)	15 W
Power consumption (printing)	300 W
Media thickness	3/7.5 mm
Maximum label width	104 mm
Maximum label length	0.4 m
Maximum roll diameter	152.4 /213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Product color	Blue, Silver
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	405 mm
Width	244 mm
Height	178 mm
Weight	8000 g