Intermec EasyCoder PF4i Service Manual

38 Intermec EasyCoder PF2i, PF4i, and PF4i Compact Industrial—Service Manual
Chapter 2—Front and Keyboard
2.4 Console pcb.
The console pcb contains an LCD (Liquid Crystal Display), three LED
(Light Emitting Diode) control lamps, and the Print button switch. It also
serves as a connection point between the keyboard and the I
2
C bus on the
CPU board.
The display has 2 × 16 character with a 5 × 7 dots matrix and background
light. 8 characters are programmable.
The left-hand LED control lamp (marked “Power”) shines green when the
power is on. Power on is also indicated by the display’s background light.
The other two LEDs are programmable using the Fingerprint instructions
LED ON and LED OFF. The center LED (marked “Ready”) is green and
blinks when data are received. The right-hand LED (marked “Error”) is
red.
The console pcb is connected to J50 at the front of the CPU board via a
permanently fi tted 10-p fl at cable. This cable must be disconnected from
the CPU board before the cover can be entirely removed. There are also
two connectors (P2 and P3) for the cables from the keyboard.
When removing the console pcb, the locking washers must be cut apart.

Intermec EasyCoder PF4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power consumption (standby)	15 W
Power consumption (printing)	300 W
Media thickness	3/7.5 mm
Maximum label width	104 mm
Maximum label length	0.4 m
Maximum roll diameter	152.4 /213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Product color	Blue, Silver
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	405 mm
Width	244 mm
Height	178 mm
Weight	8000 g