Intermec SR61

Chapter 1 — Learning About the SR61
SR61 Cordless Scanner User’s Manual 3
What’s New?
This version of the user’s guide supports the firmware version 2.0
release of the SR61 and includes these updates:
• Information to support the near-far range area imager option
• Minimum reading distance information for all scanner
options
• Support for Intermec SmartWedge™, a software wedge tool
that allows you to scan data directly to your host PC
application
You can download the latest firmware version at no charge from
the Intermec web site at www.intermec.com.
Using the Battery
The SR61 uses the AB3 lithium-ion battery as its main power
source. You need to fully charge the battery before you can use
the SR61.
Charging the Battery
Make sure you fully charge the battery before you start using the
SR61.
To charge the battery
• Place the SR61 with the AB3 battery installed in the desktop/
wall mount 1-bay charger (AC5).
Or,
• Remove the battery from the SR61, and insert the battery
into the 2-bay, 4-bay, or 8-bay (AC6, AC7, or AC8) charger.
The battery pack used in this device may ignite, create a
chemical burn hazard, explode, or release toxic materials if
mistreated. Do not incinerate, disassemble, or heat above
100°C (212°F). Charge only with Intermec Models AC5, AC6,
AC7, and AC8. Do not short circuit; may cause burns. Keep
away from children.
Use only Intermec battery pack Model AB3. Use of incorrect
battery pack may present risk of fire or explosion. Promptly
dispose of used battery pack according to the instructions.