Chapter 4 — Configuration Command Reference
40 SR61 Cordless Scanner User’s Manual
Beep Duration
Sets the length of the beeps. You can set Beep Duration to a value
from 0 to 2550 ms. When Beep Duration is set to 0 ms, the
beeper is off. Turning off the beeper does not affect the beeps
associated with Bluetooth Connect/Disconnect or Bluetooth
Device Page.
Use Beep Duration in combination with Beep Frequency and
Beep Volume to define beeps according to operator preference
and work environment.
Beep Frequency
Sets the frequency, or pitch, of the beeps. You can set Beep
Frequency to a value from 1000 to 5110 Hz.
Use Beep Frequency in combination with Beep Volume and
Good Read Beep Duration to define beeps according to operator
preference and work environment.
Beep Volume
Adjusts the volume of the beeps. You can set Beep Volume to
Low, Medium, or High.
Use Beep Volume in combination with Beep Frequency and
Good Read Beep Duration to define beeps according to operator
preference and work environment.
Bluetooth Connect/Disconnect
Connects or disconnects Bluetooth communications between the
SR61 and host computer using Serial Port Profile (SPP).
To connect to a host computer, enter the Bluetooth address of the
computer and scan the bar code with the SR61. To disconnect,
scan the disconnect bar code.
Note: To turn off the beeper, set the Beep Duration to 0. Turning
off the beeper does not affect the beeps associated with Bluetooth
Connect/Disconnect or Bluetooth Device Page.
To Next Page
Loading...
