Intermec SR61

Chapter 3 — Troubleshooting and Maintaining the SR61
SR61 Cordless Scanner User’s Manual 29
Resetting the SR61
If your SR61 does not respond when you pull the trigger, you can
reset your SR61. When you reset your SR61, the scanner control
firmware is restarted.
To reset your SR61
• Remove and install the AB3 battery from the SR61.
If you have a Bluetooth connection, the SR61 disconnects from
the host device. After a reset, the SR61 tries to reestablish a
Bluetooth connection with the host device.
Paging the SR61
If you have misplaced your SR61, but your SR61 is turned on
and within Bluetooth communication range of your host PC,
you can send the Bluetooth Device Page command from EasySet
to find your SR61.
To page the SR61
1 Start EasySet version 5.4.1 or later.
2 Select Communication > Connect.
3 Select the COM port that your SR61 is using for Bluetooth
communications, and click OK.
4 Select the Send to product check box below the commands
window.
5 In the EasySet Commands window, select Configuration
modes and utilities > Bluetooth device page.
Your SR61 beeps continuously either for 1 minute or until
you find your SR61 and pull the trigger.
Note: By default, the Bluetooth Device Page command is
disabled. You need to enable the command on the SR61 before
you can use it. For help, see the EasySet software version 5.4.1 or
later.