Intermec SR61

Chapter 4 — Configuration Command Reference
34 SR61 Cordless Scanner User’s Manual
Using Configuration Commands
A configuration command changes the way the SR61 operates.
For example, you can change the Beep Volume and make the
SR61 beeper very quiet.
You can configure the SR61:
• by sending commands to your SR61 from your PC using
EasySet.
• by sending commands to a bar code setup sheet. Then, scan
the bar codes onscreen with your SR61, or print the setup
sheet and scan the bar codes. You do not need a Bluetooth
connection to use this method.
• from your Intermec computer. Send commands to your SR61
from your Intermec computer using Intermec Settings.
• remotely from your host PC using Intermec SmartWedge. For
help, see the instructions that ship with SmartWedge.
For a list of all the commands and their default values as they are
organized in EasySet, see the next section, “Configuration
Commands By Function.”
For descriptions of each command organized alphabetically, see
“SR61 Configuration Commands” on page 39.
Note: When you first connect to an Intermec computer, only
SR61 settings common to the Intermec computer’s internal
scanner settings are changed to the internal scanner’s default
settings.