Intermec SR61

Chapter 4 — Configuration Command Reference
46 SR61 Cordless Scanner User’s Manual
2D imager mode allows you to hold the SR61xA or SR61xE in
any direction and perform a good read, regardless of the
orientation of the bar code. The ability to read bar codes in any
direction lets you use a comfortable and ergonomic hand
position.
Linear imager emulation allows you to increase your imaging
performance (similar to a laser scanner), but requires that you
hold the SR61xA or SR61xE horizontal to the 1D bar code label.
Disable All Symbologies
This command disables all symbologies. However, disabling all
symbologies does not reset symbology parameters to their default
values. To reset all symbology parameters to their default factory
settings, use the Administrator Reset Factory Defaults command.
For more information, see “Administrator Reset Factory
Defaults” on page 39.
Dutch Post
SR61xA (area imager) and SR61xE (near-far range area imager)
only. Enables or disables decoding of Dutch Post symbology.
Dutch Post is a 4-state bar code that contains addressing, as well
as customer-specific information.
EAN.UCC Composite
Enables or disables European Article Numbering Universal
Character Coding (EAN.UCC) Composite symbology. An
EAN.UCC Composite symbol consists of a linear component
(encoding the item’s primary identification) associated with an
adjacent 2D Composite Component (encoding supplementary
data, such as a batch number or expiration date). The Composite
symbol always includes a linear component to ensure that the
primary identification is readable by all scanning technologies,
and so that 2D imagers can use the linear component as a finder
pattern for the adjacent 2D Composite Component.
Error Beep
Enables or disables the error beep. Your SR61 emits an error beep
without affecting the configuration of your SR61, when you scan
a configuration bar code that is damaged or unknown.