Intermec SR61

Chapter 4 — Configuration Command Reference
54 SR61 Cordless Scanner User’s Manual
Trigger Timeout
SR61xV (linear imager), SR61xA (area imager), and SR61xE
(near-far range area imager) only. Sets the trigger timeout for the
Trigger Mode command. You can set trigger timeout from 1 to
4095 seconds.
Turn Off After Good Read
Sets how the SR61 operates in level and pulse trigger modes.
UPC/EAN
Enables or disables decoding of Universal Product Code (UPC)/
European Article Numbering (EAN) symbology. UPC/EAN are
fixed-length, numeric, continuous symbologies that use four
element widths. A scanner that is configured to decode EAN bar
codes can decode UPC, but the reverse is not true. UPC code is a
subset of EAN code.
ISBN
International Standard Book Number (ISBN) is a 10-digit
symbology that uniquely identifies books for tracking and
ordering.
Aim Aim triggering allows you to turn on the scanner
and aim the red scanner beam without causing a
decode. Releasing the trigger enables the decode.
Trigger Mode Options (continued)
Mode Description
Trigger
Mode
Turn Off After
Good Read
SR61 Behavior
Level Enabled The SR61 turns off after it successfully
reads a bar code.
Level Disabled The SR61 stays on until you release the
Scan button.
Pulse Enabled The SR61 turns off after it successfully
reads a bar code.
Pulse Disabled The SR61 stays on until the Trigger
Timeout period is reached.