Intermec SR61

Chapter 2 — Connecting and Configuring the SR61
SR61 Cordless Scanner User’s Manual 15
Connecting to an Intermec Computer
1 Turn on the SR61 by pulling the trigger.
2 Scan the Bluetooth association bar code label that ships with
your Intermec computer. If you do not have a Bluetooth
association bar code label for your Intermec computer, use
EasySet to create a Bluetooth connect bar code. For help, see
the EasySet software.
Tip: Depending on your screen resolution, you may be able
to scan this bar code displayed on your computer screen with
an SR61xA, SR61xV, o r SR6 1 xE.
The SR61 beeps once, the green status light flashes once, and
the blue Intermec Ready-to-Work™ indicator starts blinking.
On your Intermec computer, the Authen. Request dialog box
appears.
3 In the Enter PIN field, enter the default PIN (0000) and
select OK.
When the SR61 connects to your Intermec computer, the
SR61 emits a series of beeps from low to high, and the blue
Intermec Ready-to-Work indicator turns on and stays on. The
SR61 is ready to scan data.
4 Repeat Steps 1 to 3 to connect up to seven SR61s to the
Intermec computer.
Note: When you first connect to an Intermec computer, only
SR61 settings common to the Intermec computer’s internal
scanner settings are changed to the internal scanner’s default
settings.
Note: You can also use the Intermec Bluetooth Scanner Wizard
on the Intermec computer. For help, see the documentation for
your Intermec computer.