Intermec SR61

Chapter 1 — Learning About the SR61
6 SR61 Cordless Scanner User’s Manual
Understanding the Beeps
The SR61 beeps to give you audio feedback when performing
some functions. For example, you hear a beep each time you scan
a valid bar code.
Blue Intermec Ready-to-Work Indicator Description
Light State What It Means
On A Bluetooth connection with the host computer has
been established. The SR61 is ready to scan bar codes
and send data to the host computer.
Blinking The SR61 is trying to establish a Bluetooth connection
with the host computer, or the SR61 is moving out of
range of the host computer.
Off A Bluetooth connection to the host computer is not
established.
SR61 Beeps Description
Beep Sequence What It Means
Single beep The SR61 successfully decoded a bar code or
scanned a configuration bar code.
Series of beeps from
low to high
The SR61 connected to a Bluetooth host.
Series of beeps from
high to low
A Bluetooth connection has been lost.
Three beeps Data was not successfully sent to the host. The
SR61 is out of range of the host.
A configuration bar code was not successfully
scanned.
Continuous tone for
several seconds
You just scanned the Administrator Reset
Factory Defaults bar code and the non-volatile
memory is being written.
Do not remove the battery or place the SR61
in a 1-bay charger until the tone stops.
Otherwise, the firmware memory may be
corrupted.