Chapter 1 — Learning About the SR61
SR61 Cordless Scanner User’s Manual 7
You can change the beep volume for your needs and
environment. You can set the beep volume to Low (quiet),
Medium (loud), or High (very loud - default).
To turn off the beeper
•Scan this bar code:
Beep Duration - 0
\60\03\11\21\00\00\00
You can also change the beeper duration and beeper frequency.
For more information about the beeper commands, see
Chapter 4, “Configuration Command Reference.”
Continuous beeping
for 1 minute
The host PC sent the Bluetooth Device Page
command to the SR61. Once you find the
misplaced SR61, pull the trigger to stop the
beeps. For more information about paging the
SR61, see “Paging the SR61” on page 29.
Note: The SR61xV (linear imager) and SR61xL (laser scanner)
may also produce a crackle sound when you scan a stacked (2D)
bar code. For more information, see “Stacked Code Crackle” on
page 51.
SR61 Beeps Description (continued)
Beep Sequence What It Means
Note: Turning off the beeper turns off only the bar code scanning
beeps. The beeps for Bluetooth Connect/Disconnect and
Bluetooth Device Page are not affected.
To Next Page
Loading...
