Intermec SR61

Chapter 2 — Connecting and Configuring the SR61
22 SR61 Cordless Scanner User’s Manual
To restore default settings
•Scan this bar code:
Administrator Reset Factory Defaults
\60\08\55\22
Configuring Bluetooth Communications
The SR61 can communicate with a host device through
the Bluetooth communications Serial Port Profile (SPP). SPP
allows your SR61 to use the Bluetooth link as a serial port to
communicate with your host device. You can send information
from the SR61 to your serial application without having to
modify your application.
You can initiate a Bluetooth connection from either your SR61
or host device:
• SR61-initiated Bluetooth connection.
• Host device-initiated Bluetooth connection.
Configuring Security
The SR61 provides Bluetooth wireless security for transmitting
data. By default, security is active on your SR61. For maximum
security, you need to configure a Bluetooth PIN (personal
identification number).
This section assumes that you have already installed EasySet
version 5.4.1 or later.
After you scan the Administrator Reset Factory Defaults bar
code, the SR61 produces a continuous tone while writing to
the non-volatile memory. Do not remove the battery or place
the SR61 in a 1-bay charger until the tone stops. Otherwise,
the firmware memory may be corrupted.