Intermec SR61

Chapter 3 — Troubleshooting and Maintaining the SR61
32 SR61 Cordless Scanner User’s Manual
7 If you are running Microsoft Windows 2000:
a Create a Bluetooth connection between your SR61 and
host PC. For help, see the instructions that ship with the
USB Bluetooth adapter.
When your SR61 connects to the host PC, your SR61
emits a series of beeps from low to high, and the blue
Intermec Ready-to-Work indicator turns on and stays on.
b From the drop-down list box, select the COM port that
the SR61 is using for Bluetooth communications.
c Click Next.
The status bar appears, and Interlink upgrades your SR61
with the firmware file you selected. Interlink notifies you
when the upgrade is complete.
8 Click Quit.
Cleaning the SR61
Clean the scanner window as often as needed for the
environment in which you are using the SR61. To clean the
scanner window, you can use soapy water, a solution of ammonia
and water, or isopropyl alcohol.
To clean the scanner window
1 Dip a clean towel or rag in soapy water, ammonia and water
solution, or isopropyl alcohol and wring out the excess. Wipe
the scanner window. Do not allow any abrasive material to
touch the window.
2 Wipe dry with a lint-free cloth.
Note: If you have a near-far range imager, after a firmware
upgrade, you need to pull the trigger, wait for about 3 seconds,
and then pull the trigger again.
Opening the SR61 will void the warranty and may cause
damage to the internal components.