Intermec SR61

Chapter 4 — Configuration Command Reference
SR61 Cordless Scanner User’s Manual 45
Configuration Modes and Utilities
Use Configuration Modes and Utilities to:
• allow the SR61 to always accept configuration commands by
scanning bar codes or to timeout 1 minute after the last
configuration command is set by scanning a bar code.
• get the product version, sub-system versions, and Bluetooth
address of your SR61.
• page the SR61 from the host PC or turn off the SR61.
For more information and bar codes, see “Troubleshooting the
SR61” on page 26.
Consecutive Same Read Data Validation
To ensure you have a valid read before transmitting data, you can
set the SR61 to scan a bar code multiple times.
You can set Consecutive Same Read Data Validation from 0 to
10. The default value of 0 sets the scanner to automatically adapt
to the consecutive same read based on the bar code quality and
the trust level of the bar code. For example, labels with a check
digit require fewer reads than labels without a check digit.
Data Editing
Data editing allows you to edit data scanned by the SR61 before
it is transmitted to the host. You can define up to seven input
scenarios to filter the data you want to edit. For more
information, see the EasySet software.
DataMatrix
SR61xA (area imager) and SR61xE (near-far range area imager)
only. Enables or disables decoding of DataMatrix symbology, a
high density 2D matrix code that can store a large amount of
information. DataMatrix has excellent error correction abilities
and is mostly used for marking and tracking parts.
Decode Mode
SR61xA (area imager) and SR61xE (near-far range area imager)
only. Sets the imager decode mode to linear imager emulation
(1D) or 2D imager mode.