Intermec SR61

Chapter 2 — Connecting and Configuring the SR61
20 SR61 Cordless Scanner User’s Manual
5 Select the COM port that your SR61 is using for Bluetooth
communications, and click OK.
EasySet connects to your SR61 and retrieves the current
configuration of the SR61. This configurations are indicated
with blue text.
6 In the Commands window, choose configuration command
settings for your SR61.
Your SR61 is updated with the new configuration command
settings, and the settings are added to the bar code setup sheet.
To configure the SR61 by scanning bar codes
1 Start EasySet. The first time you start EasySet, the Select
product dialog box appears.
If the Select product dialog box does not appear, choose
Product > Select.
2 Select the SR61.
3 In the Commands window, choose configuration command
settings for your SR61 and add them to the bar code setup
sheet.
4 Scan the bar codes onscreen with your SR61xA, SR61xV, o r
SR61xE, or print the setup sheet and scan the commands.
When you scan bar code configuration commands, the SR61
emits a series of beeps unless the volume is turned off.
• One beep means you scanned a valid configuration
command.
• Three beeps means you scanned an invalid configuration
command.
For more information about EasySet, see the EasySet software.
For descriptions of the configuration commands, see Chapter 4,
“Configuration Command Reference.”
Note: The SR61 does not beep when you send configuration
commands online from EasySet.