INVT Goodrive 35 Series - Page 122

Goodrive35 inverters Function codes
121
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
energy by increasing the magnetic flux.
The inverter monitors the state of the motor
continuously even during the magnetic flux period.
So the magnetic flux can be used in the motor stop,
as well as to change the rotation speed of the motor.
Its other advantages are:
Brake immediately after the stop command. It does
not need to wait the magnetic flux weaken.
Better cooling for motors. The current of the stator
other than the rotor increases during magnetic flux
braking, while the cooling of the stator is more
effective than the rotor.
P08.51
Input
power
factor of
the inverter
This function code is used to adjust the displayed
current of the AC input side.
Setting range:0.00~1.00
0.56
○
P09 Group PID control
P09.00
PID
reference
source
When the frequency command selection (P00.06,
P00. 07) is 7 or the voltage setting channel selection
(P04.27) is 6, the running mode of the inverter is
procedure PID controlled.
The parameter determines the target given channel
during the PID procures.
0:Keypad (P09.01)
1: AI1
2: AI2
3: AI3
4: HDI
5:Multi-step speed set
6:MODBUS communication set
7:PROFIBUS/CANopen communication set
8:Ethernet communication set
0
○
www.barghmaher.ir