INVT Goodrive 35 Series - Page 121

Goodrive35 inverters Function codes
120
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
changing
ratio
P08.47
Frequency
setting at
power loss
0x000~0x111
LED ones: Action selection when power off.
0:Save when power off
1:Clear when power off
LED tens: Action selection when MODBUS set
frequency off
0:Save when power off
1:Clear when power off
2: Clear when stop
LED hundreds:The action selection when other
frequency set frequency off
0:Save when power off
1:Clear when power off
0x000
○
P08.48
High bit of
initial
power
consumpti
on
This parameter is used to set the original value of the
power consumption.
The original value of the power consumption
=P08.48*1000+ P08.49
Setting range of P08.48: 0~59999kWh(k)
Setting range of P08.49:0.0~999.9kWh
0°
○
P08.49
Low bit of
initial
power
consumpti
on
0.0°
○
P08.50
Magnetic
flux
braking
This function code is used to enable magnetic flux.
0: Invalid.
100~150: The bigger the coefficient, the stronger the
braking is.
This inverter is used to increase the magnetic flux to
decelerate the motor. The energy generated by the
motor during braking can be converter into heat
0
●
www.barghmaher.ir