INVT Goodrive 35 Series User Manual

Goodrive35 inverters Fault tracking
252
END
Running time
arrival
The actual running time of
the inverter is above the
internal setting running time.
Ask for the supplier and adjust
the setting running time.
PCE
Keypad
communicatio
n fault
The connection of the
keypad wires is not good or
broken.
The keypad wire is too long
and affected by strong
interference.
There is circuit fault on the
communication of the
keypad and main board.
Check the keypad wires and
ensure whether there is mistake.
Check the environment and
avoid the interference source.
Change the hardware and ask
for service.
UPE
Parameters
uploading
fault
The connection of the
keypad wires is not good or
broken.
The keypad wire is too long
and affected by strong
interference.
Communication fault.
Check the keypad wires and
ensure whether there is mistake.
Change the hardware and ask
for service.
Change the hardware and ask
for service.
DNE
Parameters
downloading
fault
The connection of the
keypad wires is not good or
broken.
The keypad wire is too long
and affected by strong
interference.
There is mistake on the data
storage of the keypad.
Check the keypad wires and
ensure whether there is mistake.
Change the hardware and ask
for service.
Repack-up the data in the
keypad.

LL
Electronic
underload
fault
The inverter will report the
underload pre-alarm
according to the set value.
Check the load and the
underload pre-alarm point.
www.barghmaher.ir

INVT Goodrive 35 Series Specifications

General

Brand	INVT
Model	Goodrive 35 Series
Category	Inverter
Language	English