terminal is valid, the inverter stop because of the
stopping command from other sources, even the
control terminal FWD/REV keeps valid; the inverter
won’t work when the stopping command is
canceled. Only when FWD/REV is relaunched, the
inverter can start again. For example, the valid
STOP/RST stop when PLC signal cycles stop,
fixed-length stop and terminal control (see P07.04).
The function code defines the corresponding delay
time of electrical level of the programmable terminals
from switching on to switching off.
Note: P05.30 and P05.31 are valid when P05.00=1.
Setting range:0.000~50.000s
To Next Page
Loading...
