Goodrive270 series VFD for fan and pump Installation guidelines
-27-
5. Remove the mounting rail.
Figure 4-18 Fixing the VFD to the cabinet crossbeam through the four fixing holes at the VFD back
6. Pay attention to the following:
(1) Detach the VFD from the cabinet by following the preceding procedure in reverse sequence.
(2) When fixing the VFD, ensure that the four mounting holes of VFD have been securely
connected to the mounting crossbeam.
(3) Use the lifting ring on the top of VFD for lifting and moving. Never apply force to the positive
and negative bus terminals.
(4) If you need to place the VFD vertically, avoid applying force to VFD sides or placing the VFD on
a tilted surface. If the tilted angle is more than 5°, the VFD may suffer rollover since the VFD
has a large size and heavy weight (about 200kg).
To Next Page
Loading...
Need help?
General
