Hardware Manual
BMS Master 4 / 4.5
Ref.: IR14417 A 15.01.2018 Page 8/76
1.1.5. SYMBOLS UND WRITINGS
Symbols and writings used in this manual:
Safety references and Warnings
are marked with this attention symbol in this manual. A signal word explains the
subject.
Special instructions are marked with this symbol.
References to other chapters or additional information are marked with this
symbol.
>Text< Text or values mentioned in context with screen masks or similar are set
between angle brackets.
>Text< Text or values for input are bold in angle brackets.
[OK] Command buttons in context with screen masks are put in square brackets.
1.1.6. GLOSSARY
SoC State of charge
DoD Depth of discharge
KL15 Input of MASTER - Wake up „Plug-IN“
KL15S Input of MASTER - Wake up „Drive“
HV High Voltage Contactor (e.g. HV+ between Battery+ and Load)
KV Contactor like HV (refers to KiloVac)
RTC Real Time Clock
VDR voltage dependent resistor, Varistor
ADC Analog Digital Converter
NTC negative temperature coefficient resistor, thermistors
PTC positive temperature coefficient resistor, thermistors
IMD Insulation Monitoring Device
To Next Page
Loading...