VII. OPERATION
41
UE type
(2) lock lever
Caution:
Park the lawn mower on level, hard ground and make
sure that the parking brakes or locking brake pedal
are applied securely.
c. Turn the key switch to the STOP (
) position to stop
the engine.
Important:
･ Never attempt stopping the engine abruptly when it is
running at high speeds.
･ Be sure to let the engine idle for about 5 minutes after
a longtime operation and then stop the engine. Abrupt
engine stopping may lead to over-heating causing
seizure.
d. Remove the starter key and cap the key hole without
fail.
(1) Key switch (3) Cap
(2) STOP position
Caution:
When you leave the lawn mower, be sure to stop the
engine and remove the starter key to prevent the lawn
mower from being started unexpectedly by children or
unauthorised people.
Important:
Be sure to cap the key hole after having removed the
starter key. Otherwise, water or dust may enter into
the switch, which may cause trouble.
4. TRAVELLING
Caution:
･ Before having become sufficiently familiar with the
operation of the lawn mower, be sure to operate it in a
place spacious and flat without obstacles and having
an unobstructed view and confirm the functioning of
each control.
･ Check the place to mow for bumps, ditches, mounds,
steps, slopes, inclination, softness, watel pools, etc.
ahead of time to avoid accidents such as turnover, fall,
side-sliding of the lawn mower.
a. Start the engine. (Refer to "2. STARTING THE EN-
GINE" at page 30.)
b. Pull reverse ( ) of the lift lever (l) lift up the mower
deck from the ground.
(1) Lift lever
Caution:
Starting to travel at high speeds without lifting up the
mower deck will cause the mower blades to hit stones
or stocks, which may result in break-down of the lawn
mower or serious accidents.
c. Release the parking brakes or brake pedal lock.
d. Turn the throttle lever to the high speed position (
)
to accelerate the engine.
Important:
Before starting to advance the lawn mower, make
sure of the safety conditions in front of and around the
lawn mower.
To Next Page
Loading...
