SXG
58
30. PERIODICAL INSPECTION TABLE
○
:
Inspection, replenishment, and adjustment
△ :Cleaning and washing
●
:Replacement ★ :Consult your dealer.
Check points
Pre-
operation
Inspection and servicing intervals
hours of operation
Intervals after that Judgement criteria
Ref.
page
50 100 150 200 250 300 350 400
Engine oil
○★●●★
Replace after initial 50 h
and then every 100 h.
Maintain the specified level. 34
Air cleaner
△△△△△△△△
Clean after every 50h. 36
Engine coolant
○
Replace every year. Maintain the specified level.
35
45
Fuel
○
Keep fuel tank always full. 36
Fuel strainer
○ △△●△
Clean after every 100h.
Replace element after
every 300h.
There should be no dust or
water in filter. 37
Fan belt
○
13.8~14.8mm
(0.54~0.58 in.) deflection
38
Electrolyte level
○○○○○○○○
Inspect after every 50h.
Level should be kept properly.
40
Engine oil filter
★★
Replace after initial 50h.
Replace after every 300h.
43
Transmission oil
○★ ★
Replace after initial 50h
and then after every 200h.
Maintain the specified level.
35
43
Hydraulic oil filter
★★
Replace after initial 50h.
and then replace after every 200h.
43
Suction filter
★★
Clean after initial 50h.
and then replace after every 200h.
44
Chain case
★★
Replace after initial 50h
and then after every 200h.
maintain the specified level 44
Brake pedal play
○
20 to 30 mm (0.8 to 1.2h.) -
Steering wheel
○★
Check after every 300h.
There should be no abnormality.
41
Ball joints of steering
system linkage
○
Check after every 300h.
Loose ball joints should be
re-tightened.
-
Tyre pressure
○
SXG 22
Front: 1.6 x 10
5
Pa (22.7psi)
Rear: 1.6 x 10
5
Pa (22.7psi)
SXG 19
Front: 1.0 x 10
5
Pa (14.2psi)
Rear: 0.7 x 10
5
Pa (9.9psi)
41
Toe-in
★
Adjust after every 300h. 1 to 5mm(0.04 to 0.20in.) 41
Wheel tightening nuts
○
There should be no loose nuts.
40
Grease-up
○○○○○○○○
Inject grease after every 50h. 48
Radiator screen
△
There should be no clogging.
45
Radiator
△
There should be no clogging.
45
Electrical apparatus
○
All should work properly. 46
Safety switches
○
All should work properly. 47
Air intake openings
△
All should work properly. 44
Bolts and nuts
○
There should be no loose ones.
-
Rubber pipes
○○○○
Check after every 100h. -
Important:
･ Above mentioned service intervals should be used as reference creteria. If working conditions are harder, earlier
service is recommended.
･ When special technology and special tools are required, consult your dealers.
To Next Page
