IV. INSPECTION AND MAINTENANCE OF MAJOR PARTS
77
IV. INSPECTION AND MAINTENANCE OF MAJOR PARTS
b. Check to see if a small amount of oil overflows
through the plug hole. If so, the level is normal. If not,
replenish with gear oil SAE80 through the plug hole
using an oil pitcher or the like.
Oil Gear oil SAE 80
Capacity
Both bevel gear cases
0.3 liter (0.07 imp.gal.)
Important:
Before replacing the level plug, by sure to wrap the
threads with sealing tape without fail, or oil may leak
through the plug.
･Replacement of oil
Important:
Replace oil after the initial 50 hours of operation and
then after every 200 hours of operation.
a. Remove the level plug and oil filler plug. Then drain all
oil by tilting the gear case.
b. Wrap the threads of the oil filler plug with sealing tape
and screw it in and supply with fresh oil through the
level plug hole using an oil pitcher.
c. Wrap the threads of the level plug with sealing tape
and re-install it.
Important:
All oil spilt on the gear case mount should be wiped
off completely with cloth. If it is not, the belt may be
smeared with oil and become slippery.
d. Re-install the belt covers.
Caution:
･ When servicing the lawn mower, place it on level, hard
ground.
･ Stop the engine and remove the starter key.
･ Apply the parking brake securely.
･ Move the lift lever forward ( ) to lower the mower to
the ground.
･ Shift the PTO lever to the STOP position ( ).
･ Service the lawn mower after the engine has cooled
down sufficiently.
With these items in mind, confirm the safety conditions
for maintenance operation without fail ahead of time.
1. INSPECTION AND REPLACEMENT OF BEVEL
GEAR CASE
･ Inspection of oil level in the bevel gear case
Important:
Check the oil level after every 50 hours of operation.
a. Bevel gear case (LH) and (RH) : Remove the level
plug located on the back side of the bevel gear case.
(1) Bevel Gear case (LH) (3) Oil filler plug
(2) Level plug
(1) Bevel Gear case (RH) (3) Oil filler plug
(2) Level plug
To Next Page
Loading...
