Command Reference Epic 950 OEM Integration Manual
Page 138 Rev G 95-05245
1 Ticket not in printer Ticket in printer
2 Not Top of Form State Top of Form State
3 (logical) Ticket loaded Ticket not loaded
4 Bar Code not Completed Bar Code Completed
5 Ticket not Completed Ticket Completed
6 Ticket not in path Ticket in path
7 MSB No paper jam Paper Jam
Note 1: This command will reset the Ticket and Bar Code Completed Status bits
Note 2: To reset the Validation and Bar Code Complete status bits, the [ESC]@
command must be issued. In addition, the Validation Complete and the Barcode
Complete are stored in Nonvolatile Memory on the printer and will remain set through a
power failure.
Validation complete is set when the Validation number is printed on the ticket. Per the
Gaming Control Board policy, the validation number must be printed first.
To Next Page
Loading...
