20
(1)
Relay Card
The optional Relay Card allows to control up to 5 fixed speed pumps (can be only
used in combination with the Master Inverter).
(2)
Control Card
The control card is used for the Master/Single Inverter and includes the I/O’s for
the digital and analogue signals (i.e. actual value input, run/fault relay output)
and the Display unit.
(3)
Display Unit
Depending to the installation position the display can be turned to your prefered
position!
(The push-buttons will change automatically when turning the display!)
(4)
Filter Card
Optional Filter Card to ensure EMC regulations for domestic environments.
(5)
Mounting Kit
The Mounting Kit consists of the Metal and the Plastic Cover. On the Plastic Cover
there are fixed the Control Card, the Display and also the additional Relay Card if
used. The Pre-mounted cable-clips, which are necessary to connect the screen of
all signal cables to HYDROVAR-ground, are placed on the Metal Cover.
(6)
Power Unit
In its standard form it will be used as Basic Inverter or as simple soft starter in a
single pump application!
When using a Master configuration the power unit is fitted with an additional
control card!
To Next Page
Loading...
Need help?
General
