jablotron JA-101K - Page 27

JABLOTRON ALARMS a.s.
Pod Skalkou 4567/33 46601 Jablonec n. Nisou
Czech Republic www.jablotron.com
||
|
JA-101K(-LAN)(-LAN3G) and JA-106K(-3G)
Security System Control Panels 27 / 110 MLJ51410
System parameter overview when the „DEFAULT“ system profile is set:
Device Parameter Option Blocking
(limitation)
Control panel Codes with a prefix
YES
NO
Control panel Code length
4
NO
Control panel Siren when partialy set NO NO
Control panel Sirens enabled YES NO
Control panel Warning about default codes YES NO
Control panel Administrator – restricted Service/ARC
iht
NO
NO
Control panel Service and ARC controls the system
YES
NO
Control panel Trial operation NO NO
Control panel Service requirement NO NO
Control panel Duress access control
YES
NO
Control panel Alarm confirmation within one section NO NO
Control panel Siren (IW output) when a tamper is
ti d
NO NO
Control panel Tamper alarm indication reset by Service NO NO
Control panel Reset enabled YES NO
Control panel Daily reset of device autobypass YES NO
Control panel Blocking when setting NO NO
Control panel Unsetting cancels alarm NO NO
Control panel Unsuccessful setting NO NO
Control panel Disable device trouble autobypass NO
YES
Control panel Delayed report to ARC NO NO
Control panel Ways of setting
Set with warning
NO
Control panel Authorization type
Standard
NO
Control panel System blocking by alarm
NO
NO
Control panel Loss of a BUS module
Fault
NO
Control panel Device autobypass
3
rd
activation YES
Control panel Alarm length
260 90…1200 sec.
Control panel Entrance delay
30 5…120 sec
Control panel Exit delay
30 5..120 sec
Radio module RF jamming detection
Disabled
NO
Keypad Optical indication setting
1.Permanently (BUS) or
4.Segment status
change (RF)
NO
Keypad Indicate Unset status YES NO
Keypad Indicate Set status YES NO
Keypad Alarm acoustic indication YES NO
Keypad Entrance delay acoustic indication YES NO
Keypad Exit delay acoustic indication YES NO
By setting the „Default“ system profile, all the mentioned parameters are pre-set back to factory settings
and all inaccessible parameters are accessed for changes to be performed. The alarm system then doesn´t
comply with the requirements of security grade 2 and also violates the requirements given by the insurance
company or local regulations. In the case of a harmful event, the insurance company doesn´t have to pay for the
damage because of broken regulations and an incorrectly programmed system caused by the installation
company.