jablotron JA-101K - Page 28

JA-101K(-LAN)(-LAN3G) and JA-106K(-3G)
Security System Control Panels 28 / 110 MLJ51410
System parameter overview when „EN50131-1, grade 2“,or „INCERT“ are set:
Device Parameter Option Blocking
(limitation)
Control panel Codes with a prefix
YES YES
Control panel Code length
4 (INCERT 6)
NO,
(INCERT YES)
Control panel Siren when partially set
NO NO
Control panel Sirens enabled YES YES
Control panel Warning about default codes YES YES
Control panel Administrator – restricted Service/ARC rights YES YES
Control panel Service and ARC controls the system NO YES
Control panel Trial operation NO NO
Control panel Service requirement NO NO
Control panel Duress access control
YES
NO
Control panel Alarm confirmation within one section
NO
NO
Control panel Siren (IW output) when a tamper is triggered YES YES
Control panel Tamper alarm indication reset by Service YES YES
Control panel Reset enabled NO YES
Control panel Daily reset of device autobypass NO YES
Control panel Blocking when setting YES YES
Control panel Unsetting cancels alarm YES YES
Control panel Unsuccessful setting YES YES
Control panel Disable device trouble autobypass
NO
NO
Control panel Delayed report to ARC
YES
NO
Control panel Ways of setting According to
system profile
YES
Control panel Authorization type
Standard
NO
Control panel System blocking by alarm
No
NO
Control panel Loss of a BUS module
Tamper always
NO
Control panel Device autobypass
3
rd
activation
NO
Control panel Alarm length
260 90…900 sec.
Control panel Entrance delay
30 5…30 sec
Control panel Exit delay
30 5..60 sec
Radio module RF jamming detection
LOW NO
Keypad Optical indication setting
2.Section status
change (BUS) or
4.Segment status
change (RF)
YES
Keypad Indicate Unset status NO NO
Keypad Indicate Set status NO NO
Keypad Alarm acoustic indication YES YES
Keypad Entrance delay acoustic indication YES YES
Keypad Exit delay acoustic indication YES YES
Remote controllers Control functions limitation NO YES
Calendar Control function limitations NO YES