Page 39= Key 1 = Key 2 = Key 3 = Maximum or consumption = Minimum or supply
Current transformer
The ratio of the current transformer is set in configurati-
on menu CONF . The secondary current can either be set
to ../1A or ../5A.
If you are in configuration menu CONF , the current
transformer ratio can be changed as follows:
A
A
SELECT CT
CONF
Select:
Confirm the selection
of the current
transformer menu with
key 2.
The text SELECT dis-
appears.
Set:
Select the number to be
changed using key 1.
The selected number
flashes. The text EDIT
appears.
Change the selected
number using key 3.
Multiply the number
with a factor 10 with
key 2.
When the ratio of the current transformer is set, press key
1 as often, as no number is flashing any longer. EDIT
disappears.
With key 3 you move to the next menu. The ratio of the
current transformer is saved.
Voltage transformer
The ratio of the voltage transformer is set in configurati-
on menu CONF. The secondary voltage can be set in the
range of 100V up to 500V.
If you are in configuration menu CONF, change the
ratio of the current transformer as follows:
A
A
SELECT CT
CONF
Select
Confirm selection of
current transformer
menu with key 3.
The text SELECT dis-
appears.
Select
With key 3 you move to
the voltage transformer
menu.
Set
Using key 1 the num-
ber to be changed is se-
lected. The selected
number flashes. The
text EDIT appears.
With key 3 the selected
number is changed.
Key 2 multiplies the
number with a factor
10.
If the ratio of the voltage transformer is set, press key 1
as often, as no number is flashing any longer. EDIT
disappears.
With key 3 you move to the next menu. The ratio of the
voltage transformer will be saved.
A
A
CT
CONF
EDIT
Primary current
Secondary current
Primary voltage
Secondary voltage
kV
V
VT
CONF
EDIT
kV
V
VT
CONF
To Next Page