P/N 960-100940R_Rev. A © 2016, JCM American Corporation
Installation GEN5™ Series Printer Section 2
Cleaning Card Cleaning Procedure
To clean the GEN5 Printer Paper Path and Sensors
using a Cleaning Card, follow this procedure:
1. Open the EGM Service Door.
2. Pull the Printer out of the EGM on its Sliding
Base.
3. Remove any loaded Tickets from the Printer
.
4. Remove the Cleaning Card from its protective
packaging (Figure 2-8).
5. Carefully insert the Card’
s
“T”-shaped notched
end into the Printer’s Ticket In Slot (Figure 2-3
a). The Cleaning Card wil
l automatically feed
into the Printer.
6. Press and hold the Feed button on the Keypad
(Figure 2-4 a) to feed the Cleaning Card through
the Paper
Path.
7. Carefully remove the Cleaning Card from the
Printer
’s Ticket Out Slot.
8. Feed 2 or 3 Tickets through the Printer to remove
alcohol residue.
NOTE: Make sure the Printer’s Power
Supply is properly connected.
NOTE: Each Cleaning Card is
intended for single use only. Always
use a new Cleaning Card for each
cleaning cycle.
To Next Page
Loading...
Need help?
General
