COMPLEX RADIO CONTROL SYSTEM
Note: if binding fails, please turn off the transmitter and receiver and
repeat the procedure.
Note: before turning on the transmitter to bind first make sure it
has been set to the correct model file.
Procedure:
3. Switch on the transmitter - the transmitter emits an acoustic
signal announcing the detection of a new receiver.
The communication between the receiver and the transmitter is
secure and of course digital. Therefore, it's necessary to bind the
device (transmitter/receiver). This is always a necessary step when
using a new receiver or transmitter. You only need to bind the
receiver once, the transmitter will remember the bound devices.
1. Insert the BIND PLUG (included in the receiver packing) into the
receiver socket labeled Ext.
3.3. Operation
We recommend that you switch on the transmitter first and then
subsequently the receiver. The transmitter confirms the switching
on of the receiver with an acoustic signal. When switching off the
system we recommend that you switch off the receiver first and
then subsequently proceed with switching-off the transmitter.
3.4. Binding
2. Switch on the receiver – (connect a proper voltage supply to the
receiver). Binding of the receiver may now be performed within 60
seconds. After the 60 seconds elapse the receiver returns to setup
mode and the binding process must be repeated by starting again
from step 1.
EN
8
To Next Page
Loading...
